With
the prices of computers dropping to all time lows (you can get
a full computer for as low as $300 after rebate!) more and more
people are getting additional computers for their home, and
networking them for a simple LAN. This is all well and good
but sometimes finding the right networking kit, and setting
it up can be a daunting task. This is where the Actiontec USB
Single-Room Starter kit comes in. Sporting an extremely easy
to setup USB to USB computer connection, this could vary well
be one of the easiest to use networking kits for the home.
Installation
The
installation of the Actiontec USB Single-Room Starter Kit was
very easy. Utilizing USB you don't even need to open your case
to install the hardware. Lately USB has been the hot ticket
in external input devices. With a faster bandwidth then traditional
serial ports, and instant installation (you don't even need
to power down your computer), it is no wonder that USB has caught
on so much.
After
plugging in the USB cables to each computer your next step would
be to load the drivers from the CD. After installing the drivers
your next step would be to reboot. Upon reboot your network
should be operating properly (after the software has taken care
of all the needed network protocols), and ready for use.
Next
>>
|